Water Damage Restoration – What Exactly Is It? It is the process of repairing a house or property to its pre loss condition. Damage to the property could be due to an overflow, flood or any other water damage event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. There are two large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) and also the RIA (Restoration Industry Association) that recommends standards for water damage and mold restoration. The S500 damage due to water guide is the benchmark tool which is used by companies focusing on restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the first and the most crucial step in water damage restoration. The assessment has to be correct so that an appropriate response can be used. In restorating the damage due to water, technicians and the insurance providers must work together and know very well what is damaged and how to make restoring the injury. Identifying the origin in the damage, documentation of damage, and accurate estimates are mandatory for any proper water damage and mold restoration. Categorization is situated on the contamination levels of the water source. The categories are highlighted below
Category 1 – This is water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This really is water that has some contaminants like water from the dishwasher, washing machine or toilet with urine.
Category 3 – This can be water that is certainly highly unsanitary and can do causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are a few examples.
Decontamination and Drying – Right after the evaluation is complete, the whole process of drying and decontaminating begins at the site. Based on the extent of damage, damage caused because of water can be classified into 4 types. Class 1 Damage- When loss is fixed to a small area and less water has been absorbed by materials. This brings about slow evaporation rate. Class 2 Damage – When the damage would be to the complete room and carpet area. Class 3 Damage – Once the entire area is saturated with water and Class 4 Damage – when there are many deep saturation pockets. Decontamination and drying is really a key stage in Water damage restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments have to be used. Decontamination needs to be done if contamination has been detected in the community. Decontamination may be performed for the whole area or even in specific pockets where contamination has been detected.
Monitoring and Completion – Monitoring the restoration process of damage caused because of damage is essential to obtain the desired results. One must be proactive through the monitoring process. Checking if the drying devices are setup properly, assessing in the event the personnel involved are qualified to do the job and checking if the equipments are in working order inwtsy all area of the monitoring process. Necessary steps should be taken if anything wrong is spotted through the monitoring process. The complete procedure of water damage restoration would be considered complete only once the humidity, temperature and the moisture content is really as per industry standards. Upon completing this type of water damage restoration process, the drying equipment can be removed.